OK, so you couldn’t make it to Fespa Barcelona. Too bad because it is a great city. FESPA had another big show February 21 – 24 and Scott Fresener was there doing lots of seminars and videos. Check out Scott’s daily show reports, interviews and much more right here on this page – or on the right of the home page of this site.
All-in-all the show was great. While the main theme of Fespa is the digital wide-format side with exhibitors like HP, EFI, Fuji, Mimaki, Mutoh and others – the FespaFabric section (while much smaller) was very well attended and the exhibitors were really busy. There wasn’t much screen printing going on other than at “Charlies Corner” (Charlie Taublieb), but the direct-to-garment guys were out in force and they were pretty much slammed all four days. A good sign!
Brother had their new “one pass” printer there, Kornit was showing their new discharge ink feature (see video interview), Anajet (see video interview) had their M series, DTG was there, Aeeon was there with renewed energy showing their high speed printer (see video interview), and more. Plus, there were a LOT of guys showing heat transfers. Transfer are still huge! The booths were very busy all four days and it seems everyone had a smile on their face! Good job – again – Fespa!
Scott Fresener Interviews Kornit Digital and talks about their new discharge ink feature.
Day Three Show Report
Day One Show Report
Scott Interview with Peter Choi and Eric Huber at the Aeoon Booth
Scott Day Two Show Report
Scott Interview with Brian Walker – Viper Pretreat Machine
Scott Interview with Charlie Taublieb
Scott Interview with Anajet
About the Author: Been around the block. Read bio here.
Leave a Reply
You must be logged in to post a comment.